Directions to the Port

Directions to the Port2018-02-14T11:47:36+00:00

Directions Main Terminals

PORT OF BEAUMONT MAIN TERMINAL 1225 Main Street, Beaumont, TX 77701 409-835-5367

Directions: To Administration, Main Gate, Operations & All Terminals. (Orange County/Jefferson Energy Terminal see directions at bottom of page)

If you are driving Eastbound or Westbound on I-10 Exit Take Exit 854, turn (south) on Spur 380 (Martin Luther King Parkway) Continue past College Street (Hwy 90) turn next left on Franklin Street. Franklin dead ends at the Port of Beaumont Main Gate. The port is directly behind the Jefferson County Courthouse. Truck Parking is to the left of the gate Check into Operations Bldg. to the right of the Main Security Gate. Administration is to the left beside the Caboose.

Note: As Beaumont’s downtown re-development plans take root, city leaders have limited trucks to and from the Port of Beaumont to main routes. Failure to follow Truck Routes may result in traffic fines for truck drivers. Note: Willow/Park Street, Main Street and Calder Ave are not designated Truck Routes & Main Street is blocked at the railroad tracks near the Port entrance. MLK to Franklin is the best route.

Orange County Terminal/Jefferson Energy

Orange County Terminal Jefferson Energy 409-783-9191 Jefferson Energy/OC-1/Barge Dock Directions:

If you are driving eastbound on I-10:  EXIT 856 “Old Hwy / Rose City” Then take the First Turn right onto “Old Hwy 90, After you cross 1st set of railroad tracks – you will make slight right, Proceed over two more sets of railroad tracks – then turn right. (Do NOT go straight thru the gates to enter the Gerdau Steel Facility) Proceed through the Gerdau Easement over several sets of railroad tracks. You will dead into the Jefferson Energy Terminal. The guard at the gate will direct you.

If you are driving westbound on I-10. EXIT 858 “Rose City” Exit. Travel about 2 miles on the service road (you are still westbound) to the U-Turn under freeway at the river. You will now be Eastbound on the I-10 service road. Take the First Turn right onto “Old Hwy 90, after you cross 1st set of railroad tracks – you will make slight right, proceed over two more sets of railroad tracks – Then turn right. (Do NOT go straight thru the gates to enter the Gerdau Steel Facility) Proceed through the Gerdau Easement over several sets of railroad tracks. You will dead into the Jefferson Energy Terminal. The guard at the gate will direct you.

Note: When you exit the site, go back to IH 10 Service Road head east proceed to the third turn around to go under the freeway for westbound traffic. Eastbound can get up onto IH10 at first open ramp.